Your kit includes a piece of vacuum line with a barb on each end, this is to eliminate the vacuum “T”.

1. Cut a few inches to the right and left of the vacuum “T” then insert the provided vacuum hose.
2. Reconnect the coolant hoses by cutting the ends off that used to be attached to the EGR cooler.
3. After the stock connector is removed from the one side you can slip the new coolant hose over the original hard pipe and fasten it on using the supplied hose clamp.

*To eliminate any risk of the coolant hose coming in contact with your radiator fan please secure it in place using a zip tie.