Description
Camshaft kit for VW TDIs with an ALH engine code, featuring the highly-reliable upgraded Franko6 Stage II camshaft. This kit includes everything that should be replaced with every camshaft replacement.
Kit Includes:
Franko6 Stage II Camshaft — 038109101K
8x Camshaft Followers (Nitride Coated) — 038109309C
Camshaft Seal — 038103085C
Camshaft Sprocket Bolt — N90502103
Joe Gibbs Assembly Lube Packet
Fits the Following:
1998-2003 VW New Beetle TDI
1999.5-2003 VW Jetta TDI
1999.5-2003 VW Golf TDI
Warranty Note: This camshaft comes with a 3-year, unlimited mileage warranty against manufacturer defects. Franko6 requires photographic documentation with any warranty requests, and reserves the right to inspect the camshaft (in some cases the complete cylinder head) to determine the cause of failure prior to any warranty approvals.
Installation Note: Proper break in of a camshaft is essential for proper functioning and longevity. Joe Gibbs Break-in oil facilitates that well. Below is the recommended process.
1. Put assembly lube on all lobes, lifter faces, distributor gears, bearing journals, lifter barrels, and oil pump gears.
2. Turn the engine over by hand to make sure that nothing is binding up (e.g. cam bearings are properly seated) and that timing is correct.
3. Rev engine to 2000-3000 RPM for 20-30 minutes. Drain break-in oil.
4. Refill with break-in oil and drive normally for about 500 miles.
5. Drain oil again and replace the filter and oil.
